Could not initialize the selected course
Posted: November 22nd, 2010, 9:06 am
The Problem
You are attempting to launch a course and you get a message stating
"Could not initialize the selected course".
What causes this?
You are missing one or more libraries used by the course. The missing library(s) is almost always a custom library.
The Solution
There a few ways to address this issue.
1. Try reinstalling the course. During installation, you should be advised of which library(s) is missing.
2. Bring up the Library Identification Tool (available in Utilities). Browse to the .crs file for the course, select it and open it. The display will tell you what libraries are needed by the course and if you are missing any of them.
3. Bring up Diguelo's Course Collator V4 (available in Utilities). Click on the course in question. That will list required libraries and identify any missing ones.
Once you have identified the missing library(s), simply download and install it (or reinstall from your backup if you have a backup).
Dar
You are attempting to launch a course and you get a message stating
"Could not initialize the selected course".
What causes this?
You are missing one or more libraries used by the course. The missing library(s) is almost always a custom library.
The Solution
There a few ways to address this issue.
1. Try reinstalling the course. During installation, you should be advised of which library(s) is missing.
2. Bring up the Library Identification Tool (available in Utilities). Browse to the .crs file for the course, select it and open it. The display will tell you what libraries are needed by the course and if you are missing any of them.
3. Bring up Diguelo's Course Collator V4 (available in Utilities). Click on the course in question. That will list required libraries and identify any missing ones.
Once you have identified the missing library(s), simply download and install it (or reinstall from your backup if you have a backup).
Dar