Page 1 of 1
Out of bounds
Posted: September 5th, 2012, 10:03 am
by bryce
Ok, I've been using the architect for over 10 years now and should know this, BUT.......is there a way to set up an area of OB or do I have to use a texture designated to OB?
Doron
Re: Out of bounds
Posted: September 5th, 2012, 6:25 pm
by BrianZ111
It's on the course routing tool. Select the hole you want to place OB on, choose OB near the bottom of the dialog box and then set points on the course like you do shot points. Any ball that crosses the line is considered OB for that hole.
Re: Out of bounds
Posted: September 6th, 2012, 1:18 pm
by Indy Anna Jones
You can also set as many OOBs on a hole as you like (or required.) Be aware that a shot path CANNOT cross over an OOB line.
Re: Out of bounds
Posted: September 6th, 2012, 2:53 pm
by bryce
Now I just feel ridiculous! I knew it was somewhere easy to find, but couldn't figure it out.
Thank you both